Two simple tools are required to replace your current Xbox 360 Controller Thumb-sticks with Evil Sticks.

• 1. T8 Torx Tool
• 2. Evil Sticks (Evil Controller designed 360 Thumb-sticks.)

First you must remove all 7 torx screws from the controller. Make sure you don't forget to take out the middle screw hidden underneath the barcode.

Once the screws have been removed, simply pull off the back plate of the controller. You can use the edges to pull it off.

Now you must remove the circuit board from the faceplate of the controller. To do this, apply pressure with your fingers to the thumb-sticks underneath the faceplate. It will push the circuit board out of the controller shell.

You can set aside the shell and focus on the circuit board itself.

You can easily pull the thumb-sticks off the posts of the controller. Simply pull it straight out.

Set your old 360 thumb-sticks aside and take your Evil Sticks and place them on the thumb-stick prong. Place the Evil Controllers logo on the thumb-stick towards the bottom for proper alignment.

We will begin putting the controller back together now that the thumb-sticks have been added. Begin by placing the faceplate on its face. Then place the rumble motors in the shell as shown in the picture.

Place the circuit board into place. It should snap in firmly at the 3 points shown. If it does not close completely, check to make sure no buttons have gotten in the way.

This step is crucial to make sure your Sync button isn't jammed up before closing the controller. It is located up on the top right, indicated in the picture. Make sure that it is flush above the circuit board.

It should look like these before closing. If it is jammed, use something very small to pop it up above the circuit board.

Now that the controller circuit board is placed in the shell, you can finally put the back plate on. Begin by first laying it on the backside of the controller, trigger first.

Now close the bottom, but make sure the battery prongs are aligned properly. They should slide in nicely to the back plate.

Now screw your controller back together and don't forget the middle screw. Enjoy your improved game play with brand new Evil Sticks !